Carpower Wanted-2/160 (22 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What power output does the Carpower Wanted-2/160 provide per channel?
The Carpower Wanted-2/160 delivers up to 160 watts total across its two channels. Actual power per channel depends on speaker impedance and operating mode; in bridged mode one channel can receive more power. For best results, match speaker impedance and avoid clipping to maintain clean sound.
How do I use the bridged mode on the amplifier?
Bridged mode combines the two channels to drive a single speaker with increased output, useful for a subwoofer. Ensure the speaker impedance is suitable for bridging, rewire the speaker to the designated bridged terminals, and reduce gain to prevent overheating and distortion during setup.
What inputs and connections does the unit support?
The amplifier provides standard RCA line inputs for easy connection to factory or aftermarket head units, plus speaker outputs and power/ground/remote terminals. Use high-quality RCA cables, secure power and ground connections, and route signal cables away from power lines to minimize interference and noise.
What filters does the amplifier provide and how should I use them?
The unit features adjustable low-pass and high-pass filters to optimize frequency distribution for speakers and subwoofers. Use the high-pass for midrange or full-range speakers to remove deep bass, and the low-pass for subs to limit high frequencies; adjust cutoffs to match speaker capabilities and crossover points.
How does the unit protect against overheating and what should I be aware of?
Thermal protection monitors internal temperature and will reduce output or shut down the amplifier to prevent damage. To avoid triggering protection, ensure adequate ventilation, avoid mounting in enclosed hot areas, use proper wiring and grounding, and prevent long periods of clipping or extreme loads.
What speaker impedance is compatible with this amplifier?
The amplifier is designed for common automotive speaker loads; typical compatible impedances include standard 2–8 ohm speakers. Using impedance lower than recommended can overload the amp and cause overheating, while significantly higher impedance will reduce available power and efficiency.
How do I set the gain controls correctly without causing distortion?
Set gains by first lowering the amplifier gain, set the head unit to about two-thirds volume, then slowly increase the amp gain until peaks are loud without audible distortion. Use test tones or music with a wide dynamic range and re-check after final installation to avoid clipping and protect speakers.
How compact is the unit and how easy is it to install in a vehicle?
The Carpower Wanted-2/160 has a compact, durable housing designed for straightforward installation in most vehicles. It fits behind seats, under cargo areas, or in trunks with adequate ventilation. Plan cable routing, secure mounting points, and allow clearance for heat dissipation during installation.
What power cable gauge is recommended for a secure connection?
For a reliable installation use appropriately sized, high-quality power and ground cables rated for the amplifier's current draw. For a compact 160 watt-class amplifier, installers commonly use 8–10 AWG wire, but longer runs or higher current demands may require thicker gauge and a fuse close to the battery.
How should I maintain the amplifier to extend its service life?
Keep the amplifier clean, dry, and free of debris, ensure solid and corrosion-free electrical connections, and provide adequate ventilation to prevent heat buildup. Periodically check fuses, mounting hardware, and wiring integrity, and avoid prolonged high-volume clipping to preserve internal components and audio quality.