MTX Audio RT501 (44 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the RMS power output of the RT501 amplifier?
The RT501 amplifier delivers 500 watts RMS at 2 ohms with THD+N ≤1% and 300 watts RMS at 4 ohms with THD+N ≤1%. These outputs are certified under CEA2006 standards.
What is the frequency response range of the RT501?
The RT501 has a wide frequency response range from 20Hz to 30,000Hz with ±1dB tolerance. This ensures accurate reproduction across the entire audible spectrum.
How do I adjust the gain on the RT501 amplifier?
To calibrate the gain: turn it all the way down (counter-clockwise), set your source volume to about 3/4, increase the gain until distortion occurs, then reduce it slightly until distortion disappears.
What is the purpose of the crossover switch on the RT501?
The crossover switch allows you to select between high-pass (HPF), low-pass (LPF), or full-range mode. In HPF position, only higher frequencies pass through; in LPF, lower frequencies are allowed.
What is the recommended power wire size for the RT501?
MTX recommends using 10mm² power wire to connect the +12V terminal of the amplifier directly to your vehicle's battery. This ensures safe and efficient current flow without inducing noise.
How do I properly ground the RT501 amplifier?
Attach a short, thick grounding cable (same gauge as power wire) from the vehicle chassis to the GND terminal on the amplifier. Ensure you remove all paint or debris for maximum conductivity and secure connection.
What should I do if there is no output sound from the RT501?
Check that your source unit volume is not muted, speaker connections are properly made, gain control is adjusted correctly, signal processors are powered on, and all speakers are functional. Ensure proper wiring between components.
What should I do if my amplifier's output becomes distorted?
Lower the head unit volume or reduce the amplifier’s gain setting to prevent overdriving the system. Distortion can occur when input levels exceed the amplifier’s capabilities, leading to poor sound quality and potential damage.
How does the EBC (External Bass Control) work on the RT501?
The EBC remote allows you to adjust bass levels from anywhere in your vehicle. It connects via the EBC port and only functions when the low-pass crossover is active, ensuring optimal subwoofer control.
What should I do if my amplifier keeps blowing fuses?
Reduce the volume level on both the source unit and the amplifier to prevent overloading. If the issue persists, there may be a fault in the amplifier itself, and it should be inspected or replaced by an authorized service center.
Related products from MTX Audio
THUNDER895
User manual 15 pages
THUNDER TC4001
User manual 17 pages
THUNDER TC6001
User manual 17 pages
THUNDER TC4004
User manual 17 pages
THUNDER TC8001
User manual 17 pages
Thunder4122
User manual 19 pages
THUNDER6500D
User manual 19 pages
THUNDER4250D
User manual 19 pages
THUNDER 282
User manual 19 pages
THUNDER81000D
User manual 19 pages
ROAD THUNDER
User manual 24 pages
MXA4002
User manual 32 pages
MXA4002
User manual 32 pages
MXA3002
User manual 32 pages
MXA3002
User manual 32 pages
MXA6004
User manual 32 pages
MXA4004
User manual 32 pages