Dea TRAFIK/N (124 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum length of the bar for the TRAFIK/N system?
The maximum length of the bar for the TRAFIK/N system is 6 meters when fully loaded with accessories.
How should the cables be connected for the electrical installation?
All cables must be in double insulation. Low-voltage safety cables should be kept separate from low-voltage cables (230V ~) by at least 4 mm in air or 1 mm through additional insulation. Use plastic canals for routing and secure them with appropriate clamps near the terminals.
What is the recommended cable type for the main power supply?
For the main power supply, use a cable of type H05VV-F with a minimum cross-section of 3x0.75mm². If the cable is installed outdoors, use H05RN-F with a minimum cross-section of 3x1.5mm².
What is the purpose of the UPS unit in the TRAFIK/N system?
The UPS unit provides automatic opening of the barrier in case of a power outage. It ensures continued operation of the system even when the main power supply is unavailable.
How many operations can be performed with a 7Ah battery when the bar is fully loaded?
With a 7Ah battery and a fully loaded bar (6 meters + accessories), approximately 35 operations can be performed.
How should the bar be manually moved?
The bar can be manually moved by rotating the handle located under the motor. The rotation must be done with the bar and balancing spring correctly installed, or without the bar and with the spring unloaded.
What is the procedure for balancing the bar?
To balance the bar, follow the steps: raise the bar manually to the open position, remove the spring lock, position the bar beyond the open position, attach the spring to the correct hole, and adjust the preload according to the balancing table. Ensure the bar settles at approximately 45° when manually closed.
How should the end stops be adjusted?
To adjust the end stops, loosen the locking nuts on the end stop cams, position the bar in the open position and adjust the open cam so it presses the microswitch, then tighten the nuts. Repeat the process for the closed position.
What is the recommended type of cable for connecting the encoder to the control unit?
Use a dedicated cable of type 3x0.75mm² for connecting the encoder to the control unit.
What should be done after installation to ensure proper functioning?
After installation, verify that all adjustments have been made correctly and that the safety and unlocking devices are functioning properly.