Beta 1899SI (226 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum operating voltage for the device?
The device operates exclusively at 12V. Connecting it to a power source exceeding 16V will damage the internal safety fuse of the electronic system.
How long does a typical cleaning cycle take?
A typical cleaning cycle for the injection system takes between 20 to 30 minutes. For the intake system, it ranges from 30 to 40 minutes, depending on the nebulization and waiting times set.
What should I do if I notice engine knocking during the process?
If engine knocking or hydrolock is detected, increase the waiting time between nebulization phases. If the knocking persists, pause the treatment and let the engine idle for at least 5 minutes before resuming.
What is the purpose of the purge function?
The purge function is used to completely drain the liquid from the tanks and tubes to prevent contamination of seals and blockage of the tubes, especially when switching between diesel and gasoline systems or after use.
What are the dimensions of the device?
The device has a length of 420 mm, height of 270 mm, and width of 385 mm. It weighs 11.6 kg and has two 3-liter tanks for cleaning fluids.
What safety precautions should I take when using the device?
Always wear protective eyewear and chemical-resistant gloves. Ensure the work area is well-ventilated, and keep fire extinguishers nearby. Avoid using the device near the engine to prevent fire hazards.
How do I connect the device to the vehicle's fuel system?
Connect the red pressure hose to the fuel pressure return fitting and the blue return hose to the fuel return fitting. Ensure all connections are secure to prevent leaks and ensure proper operation.
What should I do if the device does not start?
Check that the fuel tank has sufficient cleaning fluid and that the device is connected to a 12V power source. Ensure all connections to the vehicle's battery are secure and that the system is properly grounded.
How do I calibrate the device before starting the cleaning process?
Insert the spray nozzle into the air tank and press OK to initiate the calibration/priming procedure. This pressurizes the entire system to ensure proper operation during the cleaning cycle.
What should I do after completing the cleaning process?
After the cleaning process, drain the tanks and tubes completely by using the purge function. Disconnect all hoses and adapters, and ensure the vehicle is turned off before performing a road test at low speed.
Related products from Beta
603/10
User manual 4 pages
603/5
User manual 4 pages
1742
User manual 2 pages
1949F
User manual 2 pages
1949G
User manual 2 pages
667N
User manual 2 pages
666N
User manual 2 pages
352U
User manual 6 pages
1471PN/U
User manual 11 pages
1566/GO
User manual 11 pages
1461/C9B
User manual 12 pages
1461/C3B
User manual 12 pages
560/C6
User manual 12 pages
3012
User manual 11 pages
560/C12
User manual 12 pages
1461/C13A
User manual 12 pages
1651DGT/IP
User manual 12 pages
437K/16
User manual 12 pages
437K/33
User manual 12 pages
3012I
User manual 12 pages