W&T RS232 - Centronics (40 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What does the W&T RS232 - Centronics converter do?
The W&T RS232 - Centronics converter translates between RS232 serial signals and Centronics parallel signals, enabling reliable data exchange between devices that use different interface standards. It buffers and conditions signals to maintain data integrity in office and industrial environments and simplifies connecting legacy printers or equipment to modern serial controllers.
Which physical connectors and pinouts does this converter use?
The converter implements the standard RS232 and Centronics physical interface families, so expect common RS232 connector types (for example DB9 or DB25) and the Centronics micro‑ribbon parallel connector. The device maps standard signal names such as TX, RX and GND on the serial side and D0–D7, STROBE and BUSY on the parallel side.
What signal voltage levels are supported between RS232 and Centronics?
The converter supports standard RS232 bipolar signal levels (typically ±3 to ±15 V) on the serial side and translates them to the Centronics parallel side voltage levels commonly used in parallel printers (usually TTL/CMOS logic levels around 0–5 V). Internal level shifters protect connected equipment and ensure reliable interfacing.
Which data rates and baud rates are supported for serial communication?
The device supports common RS232 baud rates used in industrial and office applications, including low and midrange speeds typically up to standard rates such as 115200 bit/s. Actual maximum supported throughput depends on the converter implementation, so choose speeds that match both host and peripheral capabilities for error‑free transfer.
How are hardware handshakes and flow control managed between the two interfaces?
The converter maps and mediates common hardware handshake signals: it converts RS232 control lines (for example RTS/CTS or DTR/DSR where present) to the Centronics parallel handshake signals (such as STROBE, BUSY and ACK). This buffering and mapping prevent overruns and ensure synchronized transfers between sender and receiver.
Does the converter require an external power supply and how is it usually powered?
Some converters draw limited power from the RS232 interface, while others require an external supply for reliable parallel driving. Typical external supplies are low voltageDC; verify the unit’s label for required voltage and polarity. Using the correct power option ensures stable logic levels and long‑term reliability in industrial use.
Can I use this converter in harsh industrial environments?
Yes, the product is designed for use in both office and industrial environments and provides stable performance under typical conditions. For harsh conditions, follow best practices such as using shielded cables, proper grounding, and suitable mounting to reduce electrical noise and mechanical stress for long‑term reliable operation.
How should I wire the converter for a serial device to a parallel printer?
Connect the RS232 serial device TX, RX and ground to the corresponding serial pins on the converter, and wire the converter’s Centronics side to the printer data lines D0–D7 plus STROBE and ground. Match parity, stop bits and baud settings on the serial device and ensure parallel control signals are enabled for proper handshaking.
What troubleshooting steps help if data is lost or corrupted?
If you experience errors, first check cable integrity and secure connector seating. Verify matching serial parameters (baud, parity, stop bits), confirm flow control settings, and reduce cable lengths or add shielding to limit interference. Swapping components or testing with a known working device can isolate whether the serial side, converter, or parallel peripheral is at fault.
What typical applications is the RS232 to Centronics converter used for?
Typical applications include connecting legacy parallel printers to serial hosts, integrating older lab instruments or industrial controllers with modern serial systems, point‑of‑sale peripherals and retrofitting equipment that requires serial‑to‑parallel bridging. The converter is valuable where reliable cross‑interface communication is needed without redesigning existing devices.