Vox DelayLab (88 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I set the delay time using the SYNC function?
The SYNC function allows you to synchronize the delay time to the tap tempo. When enabled (LED is on), the delay time is set based on the tempo. When disabled (LED is off), the delay time is set in milliseconds.
What is the purpose of the TAP/BANK UP switch?
The TAP/BANK UP switch is used to set the delay time by pressing it twice. It also allows you to switch between banks. When the SYNC function is on, it displays the tempo (BPM) and blinks in red.
How do I save edited effects to a program?
To save edited effects, press the WRITE button. The save destination will blink on the display. Use the TAP/BANK UP switch and Channel switches A–C to select the save destination. Press WRITE again to start the save function. If the display is blinking, pressing WRITE initiates the save.
What should I do if the batteries are low?
When the battery charge is low, the display shows 'Lo'. Low batteries can cause settings to be lost. Ensure you save your settings before the batteries are depleted. To set the battery type correctly, refer to the 'Setting the battery type' section.
How do I disable the Key Lock function?
To disable the Key Lock function, hold down the CANCEL button for approximately two seconds. This will unlock the top panel buttons, knobs, and selectors, allowing normal operation.
How do I connect the DelayLab in mono?
For mono connection, connect your guitar to the INPUT (L/MONO) jack and the output to the OUTPUT (L/MONO) jack. This ensures the signal is processed in mono mode, suitable for most amplifiers and mixers.
What is the Auto Power-Off function?
The Auto Power-Off function automatically turns off the DelayLab after four hours of inactivity. This helps conserve battery life. To reactivate, reconnect the INPUT (L/MONO) cable and power on the unit.
How do I enable the Auto Power-Off function?
To enable the Auto Power-Off function, press and hold the CATEGORY button and TAP/BANK UP switch, then connect a cable to the INPUT (L/MONO) jack. This activates the function, which is saved even when the power is off.
How do I use the looper effects?
To use looper effects, select 'LOOPER' on the Type Selector knob. Choose the looper type (Standard, Vintage, or Custom) using the CATEGORY button. Adjust the settings with the TIME, FEEDBACK, TONE/SPEED, and MIX knobs. Press the WRITE button to save the looper settings.
How do I adjust the loop volume?
Use the INTENSITY knob to adjust the volume of the loop phrase. This controls the balance between the loop sound and the direct input signal, allowing you to fine-tune the output level for your setup.