Behncke SWT 100 (100 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum allowable operating pressure for the heat exchanger?
The maximum allowable operating pressure for the heat exchanger is 1000 kPa (10 bar) on the heating water side and 300 kPa (3 bar) on the bathwater side. Exceeding these pressures can lead to leaks or damage.
What are the recommended water quality parameters for the heat exchanger?
For QWT and SWT models, the maximum chloride content is 500 mg/l, free chlorine is up to 1.3 mg/l, pH should be between 6.5 and 8.2, and salt content is not applicable. For WTI and SWT-T models, chloride content can be up to 3000 mg/l, free chlorine is unlimited, pH remains between 6.5 and 8.2, and salt content should not exceed 3.5%.
What are the installation requirements for the heat exchanger?
The heat exchanger must be installed in a frost-free, dry room with a non-aggressive atmosphere. Ensure that the maximum operating pressure is not exceeded on either side, and that the installation allows for easy access for maintenance and inspection.
What are the safety precautions when handling the heat exchanger?
Always follow the installation instructions carefully. Ensure that the heat exchanger is only used for its intended purpose, and avoid exceeding the maximum operating pressure. Regularly inspect the heat exchanger and its connections for leaks or visible damage during operation.
What are the technical specifications for the QWT 100 model?
The QWT 100 model has a minimum pump flow rate of 16 m³/h for heating water at 70°C and 3 m³/h for bathwater. It has an inlet connection of 1 1/2" and an outlet of 3/4". The model is suitable for use with water containing up to 500 mg/l chloride.
What are the technical specifications for the SWT 100 model?
The SWT 100 model has a minimum pump flow rate of 20 m³/h for heating water at 50°C and 3 m³/h for bathwater. It has an inlet connection of 1 1/2" and an outlet of 3/4". The model is suitable for use with water containing up to 500 mg/l chloride.
What are the technical specifications for the WTI 100 model?
The WTI 100 model has a minimum pump flow rate of 16 m³/h for heating water at 70°C and 3 m³/h for bathwater. It has an inlet connection of PVC DN40 and an outlet of PVC DN40. The model is suitable for use with water containing up to 3000 mg/l chloride.
What are the installation options for the heat exchanger?
The heat exchanger can be installed either above or below the water level. Ensure that the installation allows for proper flow and pressure conditions, and that the system is properly sealed to prevent leaks or contamination.
What are the maintenance requirements for the heat exchanger?
Regular maintenance includes inspecting the heat exchanger and its connections for leaks or damage. Ensure that the system is properly winterized in cold environments and that all safety checks are performed before each use.
What are the risks of improper installation or operation?
Improper installation or operation can lead to leaks, damage to the heat exchanger, or contamination of the bathwater. It can also result in overheating of connected pipes, which may cause thermal stress and damage to the system components.