deville C07887 (88 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the nominal power of the Turbo Insert?
The nominal power of the Turbo Insert is 11 kW. This is achieved under a draft pressure of 12 Pa, during a one-hour burn period with a load of 3.7 kg of unsplit hardwood (such as ash, oak) with a diameter of approximately 7 cm.
What is the maximum load capacity for the Turbo Insert?
The maximum load capacity for the Turbo Insert is 12 kg of wood. This ensures safe and efficient operation without exceeding the maximum power output.
How should the walls adjacent to the Turbo Insert be insulated?
The walls adjacent to the Turbo Insert should be insulated to limit the temperature rise to 65 K (degrees Celsius above ambient temperature). The insulation should be rigid, capable of withstanding high temperatures (MO classification), and placed at least 400 mm from the front of the insert.
What is the recommended air intake size for the Turbo Insert?
The air intake section should be at least a quarter of the chimney flue section. For closed doors operation, the minimum size is 50 cm², and for open doors operation, it should be 200 cm².
How should the hot air distribution be installed?
Hot air distribution should be installed using 125 mm diameter air vents. These should be placed in the adjacent rooms, with at least 16 cm clearance between the air ducts and combustible materials. The ducts should be insulated and installed vertically as much as possible to promote natural convection.
What is the electrical power requirement for the Turbo Insert?
The Turbo Insert requires a 230 V power supply with a nominal power of 40 W. The cable should be connected to a universal disconnect device with a contact gap of at least 3 mm, and the earth connection (green and yellow wire) must be properly installed.
How should the Turbo Insert be installed in an existing hearth?
When installing the Turbo Insert in an existing hearth built with refractory materials, the flue must be sealed at the base to prevent air intake. The flue connection should be made using refractory mortar, and the flue diameter should be at least 180 mm.
How should the Turbo Insert be secured in the hearth?
The Turbo Insert should be secured using the provided side brackets. These brackets should be attached to the sides of the insert before placing it in the hearth, allowing for easy clipping without excessive play. The brackets should be positioned at the bottom of the hearth.
How should the air damper be adjusted?
The air damper should be adjusted to ensure proper airflow through the intake and exhaust vents. If the airflow is uneven, the size of the active vent should be reduced until all vents are balanced. A safety air passage of 10 mm must be maintained to prevent overheating.
What materials should be used for insulation around the Turbo Insert?
Insulation materials should be non-combustible (MO classification) and capable of withstanding high temperatures. Examples include 30 mm thick rock wool covered with aluminum foil, or 80 mm thick insulating brick with a thermal conductivity below 0.1 W/m°C.