Selve commeo Control (96 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to select a receiver in commeo mode?
To select a receiver in commeo mode, press the SELECT button for 3 seconds to enter the SELECT mode. The status LED will blink quickly as the sender searches for receivers. A green LED indicates receivers are found, and the LED will blink slowly orange. The first receiver will perform a short confirmation run. If no receivers are found, the status LED will light red.
How to enter the SELECT mode for a sender?
To enter the SELECT mode, press the SELECT button on the sender for 3 seconds. This places the sender in SELECT mode, allowing it to communicate with one selected receiver. Only one receiver can be controlled and adjusted at a time.
How to reset the receiver to factory settings?
To reset the receiver to factory settings, hold the PROG button for 9 seconds. This will clear all stored sender information and restore the receiver to its original factory configuration. This is useful if the receiver is malfunctioning or needs to be reprogrammed.
How to delete the sender table in the receiver?
To delete the sender table in the receiver, hold the PROG button for 6 seconds. This will remove all previously learned senders from the receiver's memory, allowing for a clean slate for reprogramming or reconfiguration.
How to add or remove a sender in commeo mode?
To add a sender, press the PROG button for 1 second while the sender is in SELECT mode. A green status LED indicates successful learning. To remove a sender, press the PROG button for 1 second with a red status LED. This allows for precise control over which senders are recognized by the receiver.
What is the SELECT mode used for?
The SELECT mode is used to choose a specific receiver for control. It allows the sender to communicate with only one receiver at a time, ensuring accurate and targeted operation. This is essential for managing multiple receivers or avoiding interference between them.
How to switch between receivers in SELECT mode?
To switch between receivers in SELECT mode, press the SELECT button for 1 second. This will cycle through the available receivers, with each one performing a short confirmation run. Only one receiver can be controlled and adjusted at a time.
What happens if no receivers are found in SELECT mode?
If no receivers are found in SELECT mode, the status LED on the sender will light red. This indicates that the sender could not detect any receivers. Ensure that the receiver is powered and within range, and try again.
How to exit the SELECT mode?
To exit the SELECT mode, press the SELECT button for 3 seconds. This will return the sender to its normal operating mode. The status LED will stop blinking and return to its default state.
What are the different status LED indicators for the sender?
The status LED on the sender provides visual feedback on its operating state. A flashing green LED indicates the sender is in SELECT mode, a flashing orange LED indicates the receiver is in SELECT mode, and a flashing red LED indicates an error or failed communication.