Dimplex SI 100TE (68 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum tilt angle for installation?
The heat pump must not be tilted more than a maximum of 45° in any direction to ensure safe and efficient operation.
How should I prepare the heating system before connecting the heat pump?
Before connecting the heat pump, flush the heating system to remove any potential contaminants or residues from sealing materials. This prevents blockages that could lead to complete failure of the unit.
What is required for the refrigerant side connection?
The refrigerant circuit must be checked annually for leaks if the device contains 3 kg or more of refrigerant, as per Regulation (EC) No. 842/2006.
What is the recommended temperature range for low-temperature heating?
A low-temperature heating system with supply temperatures between 30 °C and 50 °C is suitable for energy-efficient operation, as it reduces electrical consumption compared to higher temperature systems.
What type of antifreeze should be used in the ground loop?
The solution must contain at least 25% monoethylene glycol or propylene glycol-based antifreeze. It is essential to mix this before filling the system to ensure frost protection down to approximately -14 °C.
How should I install temperature sensors for the heat pump?
Temperature sensors must be installed in a location that captures all weather influences without distortion, avoiding direct sunlight and proximity to windows or doors. Ensure they are mounted on an insulated wall surface if possible.
What is required when connecting the heating system side of the heat pump?
The heating system must be flushed before installation to remove any potential contaminants that could damage internal components, such as the evaporator. After installation, fill and bleed down the system properly.
How should I connect the electrical supply for the heat pump manager?
Connect the control cable in the switchgear of the heat pump to terminals X1: L/N/PE, and the load cables to X5: L1/L2/L3/PE. Ensure all necessary protective devices are installed according to local regulations.
What is required for frost protection during installation?
If there's a risk of freezing conditions, ensure that the heat pump manager’s anti-freeze function operates correctly by keeping it powered and allowing proper circulation through the system. In case of power failure or shutdown, drain the heating circuit to prevent damage.
What are the recommended water quality parameters for operation?
To ensure optimal performance, maintain total hardness below 11.2 dH, total alkalinity less than 0.02 mmol/l, and a minimum flow rate of at least 35 liters per minute to prevent scaling in heating systems.
Related products from Dimplex
KAH 150
User manual 8 pages
LA 26PS
User manual 52 pages
SI 14ME
User manual 52 pages
SI 5ME
User manual 52 pages
LA 35TUR+
User manual 56 pages
LA 11AS
User manual 56 pages
MMH 50
User manual 28 pages
WWM 50
User manual 28 pages
UPH 90-32
User manual 28 pages
UPH 90-25
User manual 28 pages
WI 22 TE
User manual 60 pages
WI 22 TE
User manual 64 pages
WI 18 TE
User manual 60 pages
WI 18 TE
User manual 64 pages
LA 40TU
User manual 60 pages
SI 130TE
User manual 52 pages
LA 20AS
User manual 48 pages
LA 20AS
User manual 52 pages
VWU 65
User manual 32 pages
UPH 60-32
User manual 32 pages