ITV ICE QUEEN (132 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to ensure the machine is properly grounded?
It is mandatory to ground the equipment to avoid possible discharges on individuals or damages to the equipment. The machine should be grounded according to local and/or national regulations. The manufacturer shall not be held responsible for damages arising due to the lack of proper grounding.
What are the temperature requirements for the machine?
The machine is designed to operate at room temperatures between 5ºC (41ºF) and 43ºC (109.40ºF). The inlet water temperature should be between 5ºC (41ºF) and 35ºC (95ºF). Operating below the minimum temperature can excessively strain the motor, while exceeding the maximum temperature can shorten the compressor's lifespan and reduce ice production.
What should be done if the front louver is not sufficient?
If the front louver is not sufficient, the exit may be obstructed or the machine may receive hot air from another device. In such cases, it is recommended to install a water condenser if the machine cannot be relocated. Ensure the water piping does not pass near heat sources to maintain ice production.
How to level the machine?
Thread the support legs to the base of the machine and regulate the height to ensure the equipment is perfectly leveled. The machine should be placed in such a way that there is a minimum space between the back and the wall to allow easy access and prevent risks to the cable jack.
What is the recommended water pressure for the machine?
The water pressure should be established between 0.7 and 6 Bar (10 / 85 psi). If the pressure exceeds these values, install the necessary corrective devices. The bib connection pressure should never be reduced, even if the input pressure is higher than 6 Bar (85 psi).
How to adjust the water level in the machine?
The water level function maintains the necessary flow on the evaporator and stops the machine until the water reaches the container again. The optimum level is indicated horizontally in the figure. Adjust the float valve by turning it upwards to increase the level or downwards to decrease it. Always grasp the metallic arm, never the float itself.
What should be done before starting the machine?
Before starting the machine, ensure it is properly leveled, the voltage and frequency match the nameplate specifications, the discharge connections are operating, and the water pressure is within the recommended range. For modular machines, verify that the motor is rotating in the correct direction after removing the cover.
How often should maintenance and cleaning be performed?
Maintenance and cleaning intervals depend on the location and water quality. At least one revision and cleaning should be performed every six months. In dusty environments, it may be necessary to clean the condenser monthly. Always disconnect the machine from the power supply before performing any cleaning or maintenance operations.
How to clean the water condenser?
To clean the water condenser, disconnect the machine, close the water inlet, and prepare a solution of 50% phosphoric acid and distilled or demineralized water. Circulate the solution through the condenser, preferably at a temperature between 35ºC [95ºF] and 40ºC [104ºF]. Do not use hydrochloric acid for this process.
What should be done to prevent water leaks?
When working on the machine, always check the water connections, the status of the clamps, and the hoses to avoid leaks and prevent damages or floods. Ensure all connections are secure and properly sealed to maintain the integrity of the system.