Bosch MIC7000 (128 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How many sunshield shells are included in the package?
The package includes two sunshield shells labeled 'A' and one sunshield shell labeled 'B' without vents. These are used for different installation scenarios depending on the camera setup.
What tools are required for installing the sunshield?
You will need a Phillips-head screwdriver (#2) to remove factory-installed plastic screws from the camera head and a Torx driver (T20) for the M4 Torx head screws.
Can the sunshield be installed on a camera with an illuminator?
Yes, the sunshield can be installed on a camera with an illuminator, but you must use the shell labeled 'B' without vents. Ensure the illuminator is installed first before attaching the sunshield.
What should I do if my camera will be canted?
If your camera will be canted, you should install the sunshield first before mounting the camera in a canted position. This ensures proper alignment and functionality.
How do I align the sunshield shells during installation?
Align the sunshield shells so that the pins slide into the bolt heads on the faceplate. This ensures a secure and correct fit when attaching the sunshield to the camera.
What is the recommended torque for the M4 x 8 screws?
The recommended torque for the M4 x 8 screws is 2.2 N m (19.5 in. lb). Use a torque screwdriver if available to ensure proper tightening without over-tightening.
Are there any special considerations for extreme low temperature models?
Extreme low temperature models do not support the installation of a sunshield. Ensure that you are using a standard model if you plan to install the sunshield.
How do I mount the sunshield on the camera head?
Ensure that the sunshield mounting holes align with the holes in the rear of the camera head. Install the four screws and washers provided to secure the sunshield in place.
What should I do after installing the sunshield?
After installing the sunshield, operate the tilt to near the upper limit to ensure the sunshield is properly positioned. Then, apply power and connect the camera using a web browser or VMS.
Can the sunshield be used on a camera without an illuminator?
Yes, the sunshield can be used on a camera without an illuminator. In this case, use the shell labeled 'A' and follow the installation steps provided in the guide.
Related products from Bosch
NBN-832
User manual 2 pages
DINION IP thermal 8000
User manual 2 pages
NHT-8000
User manual 2 pages
DINION HD
User manual 2 pages
NUC-21002-F2
User manual 2 pages
NUC-21012-F2
User manual 2 pages
MIC-7130
User manual 2 pages
MIC-7130
User manual 44 pages
MIC IP starlight 7000i
User manual 2 pages
MIC-7230
User manual 2 pages
MIC-7230
User manual 44 pages
MIC IP starlight 7000
User manual 2 pages
MIC-7502
User manual 2 pages
VG4-200
User manual 8 pages
MIC IP dynamic7000 HD
User manual 44 pages