Stanley FatMax FMHT1-77442 (222 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I install AA batteries in the laser?
To install AA batteries, turn the laser upside down, lift the latch to open the battery compartment, insert four new, high-quality AA batteries with correct polarity, and close the compartment. Ensure the battery level is above 5% for optimal performance.
What should I do if the laser is not self-leveling?
If the laser is tilted more than 4°, it will flash twice and continuously on the keypad. This indicates the laser is not level. Reposition the laser on a flat surface and check the self-leveling function again.
How do I check the horizontal line accuracy?
To check horizontal line accuracy, place the laser on a flat surface, turn it on, and press the button to display a horizontal line. Measure the distance between points P1 and P3 using the specified allowable distances to ensure accuracy.
How do I check the vertical line accuracy?
To check vertical line accuracy, measure the height of a door jamb, place the laser at the correct position, and press the button to display a vertical line. Align the laser with reference points and measure the distance between P1 and P4 to ensure accuracy.
What is the procedure for checking the plumb dot accuracy?
To check plumb dot accuracy, mark points on the floor and ceiling, position the laser so the down dot is centered over the floor point, and mark the up dot on the ceiling. Measure the distance between P2 and P3 to ensure it meets the allowable distance for accuracy.
How do I test the level dot accuracy?
To test level dot accuracy, place the laser between two parallel walls, mark the dot positions on each wall, and measure the vertical distance between P1 and P3. Compare the measurement with the allowable distance for the specified wall distance to ensure accuracy.
What should I do if the laser is not working properly?
If the laser is not working properly, check the battery level, ensure the laser is on a flat surface, and verify the self-leveling function. If the issue persists, measure the allowable distances between points and contact an authorized service center for further assistance.
How do I use the mounting block?
To use the mounting block, extend it to align the laser with the mounting hole, ensuring the down dot is centered over the edge of the steel beam. For floor mounting, pull out the block until it clicks into place to allow the laser line to display through the mounting hole.
What safety precautions should I take when using the laser?
Always wear eye protection, avoid staring into the laser beam, and keep the laser away from reflective surfaces. Do not use the laser in explosive atmospheres or near children. Store the laser out of reach of untrained users and follow all battery safety guidelines.
How do I turn the laser on?
To turn the laser on, slide the Power/Transport Lock switch to the right to the Unlocked/ON position. Ensure the battery level is above 5% for proper operation. If the laser does not turn on, check the battery and reposition the laser on a flat surface.