Protimeter Grainmaster i (144 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I switch the Protimeter Grainmaster i on?
To switch the instrument on, press the button once. This will also initiate a moisture measurement. The display will show H2O in the top left-hand corner if in internal measurement mode.
How do I select a crop calibration?
Use the and buttons to scroll through the crop calibrations. Ensure the selected crop matches the sample you are measuring, and switch between moisture and temperature displays using the same buttons.
Can I adjust the pre-programmed calibrations?
Yes, each of the 15 pre-programmed calibrations (excluding the 0-100 scale) can be adjusted individually by ±1.5%. This allows for minor variations due to crop type, growing conditions, or geographical location.
What is the purpose of the external moisture and temperature probes?
External probes are used to monitor the moisture and temperature levels of stored grain, baled hay, and straw. They provide quick readings but are not a substitute for ground sample measurements, which are more reliable.
How do I use the optional moisture and temperature probe GRN3005?
Insert the probe into the grain, allow a few minutes for temperature stabilization, then connect it to the instrument. Press the button to switch on and confirm the display shows 'PROBE'. Use the and buttons to select the correct crop calibration.
How do I clean the grain cell?
Ensure the grain cell is clean before each measurement. If it is dirty, use the cleaning brush provided to wipe it down. Always clean the cell before starting a new test to avoid contamination.
How do I prepare the grinder-compressor unit for use?
Ensure the plunger is fully retracted by sliding the switch on the rotating handle forward into the compress position and rotating the handle anti-clockwise until the clutch clicks. Check that the unit is clean and operating smoothly.
How do I measure moisture content of a 10 ml sample?
Place the sample into the hopper of the grinder-compressor unit, then rotate the handle clockwise to grind the sample into the grain cup. Once the sample is ground, compress it by aligning the rotating handle and pushing the switch into the compress position. Press the button to display the moisture content.
How do I display the temperature of the sample?
After displaying the moisture content, press the or buttons to switch to temperature display. Ensure the reading has stabilized before recording the value. Temperature readings are displayed in either °C or °F, depending on your settings.
What should I do after completing a measurement?
Once the measurement is complete, turn the handle anti-clockwise to fully retract the plunger. Remove the grain cup and tested sample, and clean the grain cell with the brush. Store the instrument in a safe place for the next use.