NetApp FAS2820 (27 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I replace the boot media on FAS2820?
To replace the boot media on FAS2820, you must remove the impaired controller module, install the replacement boot media, and transfer the boot image to a USB flash drive. Ensure you have a USB flash drive formatted in FAT32 with sufficient storage for the image_xxx.tgz file.
What is the boot media used for on FAS2820?
The boot media stores a primary and secondary set of system files (boot image) that the system uses during startup. Depending on your network configuration, you can perform either a non-disruptive or disruptive replacement of the boot media.
How do I check if my ONTAP version supports NetApp Volume Encryption?
To check if your ONTAP version supports NetApp Volume Encryption (NVE), run the command 'version -v'. If the output contains '1Ono-DARE', NVE is not supported on your cluster version. If it is supported, download the ONTAP image with NVE; otherwise, download the image without NVE.
How do I determine which key manager is active on my system?
To determine which key manager is active, run the command 'security key-manager keystore show' for ONTAP 9.14.1 or higher, or 'security key-manager show-key-store' for ONTAP 9.13.1 or earlier. The output will indicate whether EKM, OKM, or no key manager is active.
What should I do if the key manager's restored status is not true?
If the restored status is not true, restore the external authentication keys using the command 'security key-manager external restore'. If the command fails, contact NetApp Support. Verify that all authentication keys show 'true' in the restored column before proceeding to shut down the impaired controller.
How do I safely shut down the impaired controller?
To safely shut down the impaired controller, first ensure that all authentication keys are restored and the system is in a stable state. If using an external key manager, run 'security key-manager external restore' and confirm all keys are restored. If using onboard key manager, run 'security key-manager onboard sync' and verify the keys are restored before proceeding.
How do I access the loader prompt on the impaired controller?
To access the loader prompt, press Ctrl+C when prompted and respond with 'y' to exit the system prompt. Then, use the command 'printenv' to capture all boot environment variables, which should be saved in your log file for reference.
What should I do if the system is waiting for giveback?
If the system is waiting for giveback, press Ctrl+C and respond with 'y' to proceed. This will allow you to take over or stop the impaired controller from the healthy controller using the command 'storage failover takeover -ofnode impaired_node_name'.
How do I remove the controller module?
To remove the controller module, first ensure you are properly grounded. Disconnect the cable harness, remove the system cables and SFPs, and unlock the latch to fully open the controller module. Carefully pull the module out of the chassis using both hands.
How do I access the onboard key manager backup information?
To access the onboard key manager backup information, enter the advanced mode using 'set -priv advanced' and then run 'security key-manager onboard show-backup'. Save the backup information in a separate file or log for use in disaster recovery scenarios where manual restoration of OKM is required.