Viessmann VITOPLANAR (124 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum power rating for the connected heat emitters?
The Vitoplanar Dimmmodul for EG3 allows connection of heat emitters up to a maximum power rating of 2000W.
What tools are included in the delivery package?
The delivery package includes a mounting and operating manual, the Vitoplanar Dimmmodul for EG3, and fastening materials such as two M4x10 hexagon socket screws, two 4.3mm gear wheels, and one 3mm hex key.
How do you mount the Dimmmodul?
To mount the Dimmmodul, first pull the power cable from the heat emitter. Attach the Dimmmodul to the rear of the emitter, secure it with two M4x10 hexagon socket screws and a 4.3mm gear wheel, then connect the cable to the Dimmmodul and turn on the circuit.
How do you turn the heat emitter on or off using the remote control?
To turn the heat emitter on or off, briefly press the learned channel button on the remote control. This will switch the connected heat emitter on or off.
How do you adjust the heating power using the remote control?
To adjust the heating power, hold the button on the remote control for a longer period. This will gradually increase the heating power from the off state to the desired level, or decrease it to the minimum setting of 30%.
What is the range of the remote control?
The remote control has a range of approximately 20 meters in open space. It operates on a frequency of 433.92 MHz and uses a CR2032 battery with a voltage of 3 volts.
How do you synchronize multiple heat emitters?
To synchronize multiple heat emitters, first set all emitters to the on state using the 'Anfahren' function. Then, briefly press the button on each receiver to turn them off. Finally, use the 'Anfahren' function again to set all receivers to the same heating level simultaneously.
How do you program the remote control for the first time?
To perform the initial programming, connect the heat emitters to the power supply. Press the desired button on the remote control briefly to initiate the programming process. Confirm the programming by pressing the same button again. End the process by pressing a button for a longer period.
How do you delete a programmed heat emitter?
To delete a programmed heat emitter, hold the 1 and 2 buttons on the remote control for more than three seconds until the red indicator light turns on. Then press the button associated with the previously used channel for about one second to send the deletion signal.
What should you do if the remote control battery is low?
If the remote control battery is low, replace it with a CR2032 battery, ensuring the positive side is facing up. Carefully open the remote control casing, remove the old battery, insert the new one, and reassemble the unit in reverse order.