LD Systems DP600 (64 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I turn the amplifier on or off?
To toggle the power, press the POWER SWITCH located on the front panel of the device.
What does the PROTECT LED indicate?
The PROTECT LED turns red when overheat occurs or DC is detected at the power amp blocks. This protection circuit activates for 3 seconds after turning the amplifier on.
When should I adjust the GAIN controls?
Adjust the GAIN controls to increase gain by turning clockwise and decrease it by turning counter-clockwise, especially when signal levels are too high or low.
What does the SIGNAL LED indicate?
The SIGNAL LED illuminates based on input signal level: -35dB (normal), -15dB, -10dB, and -5dB. If no indication is present, check gain settings and ensure proper audio source connection.
How do I connect the speaker cables?
Use high-quality balanced XLR or Speakon connectors for reliable connections. Ensure shorter lengths and larger wire sizes to minimize power loss and maintain damping factor. Avoid placing speaker cables near input wiring.
What is the purpose of the GROUND SWITCH?
The GROUND LIFT feature allows you to break a connection between chassis earth and electrical earth, useful when 50Hz hum is present from loudspeakers.
How do I switch between STEREO and BRIDGE modes?
In STEREO mode, both channels operate independently. In BRIDGE mode, combine both channels into a single output with twice the voltage using only channel A input and set channel B gain to minimum.
What is the frequency range of these amplifiers?
The frequency response ranges from 20 Hz to 20 kHz across all models, ensuring accurate reproduction of audio signals within this spectrum.
How do I connect balanced cables for optimal performance?
Use high-quality balanced XLR cables with separate shielding. This minimizes external interference and noise by connecting the shield to all metal chassis parts, improving signal integrity.
What is covered under the Limited Warranty?
The Limited Warranty covers defects in materials or workmanship for 2-5 years from purchase. It applies only to original purchasers and includes repair or replacement of defective components, with removed parts becoming property of Adam Hall.