Axis OfficeBasic USB Wireless G (125 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What safety precautions should I take when installing the AXIS OfficeBasic USB Wireless G?
Before installing the AXIS OfficeBasic USB Wireless G, read all safety notices carefully. Observe all safety markings and instructions when using the product. Ensure you fully understand the implications of any safety warnings to avoid operational issues.
Which regulatory standards does the AXIS OfficeBasic USB Wireless G comply with?
The AXIS OfficeBasic USB Wireless G complies with EN55022 for radiated emissions and EN55024 for immunity in Europe. In the USA, it complies with FCC Part 15 rules. In Japan, it is a class B product under the VCCI standard.
How do I set the correct channel for the AXIS OfficeBasic USB Wireless G?
The channel must be set according to the radio frequency requirements in your country. Ensure you select the appropriate channel based on local regulations to avoid interference and ensure proper operation.
What are the wireless operating modes supported by the AXIS OfficeBasic USB Wireless G?
The AXIS OfficeBasic USB Wireless G supports two wireless operating modes: Infrastructure mode, where devices communicate through an access point, and Ad-hoc (Peer-to-Peer) mode, where devices communicate directly without an access point.
How do I install the AXIS OfficeBasic USB Wireless G in Infrastructure mode?
To install the AXIS OfficeBasic USB Wireless G in Infrastructure mode, connect the print server to your printer using the USB cable, power on the printer, and connect the power adapter. Wait for the LEDs to stabilize, then press the Reset button for 5 seconds to start the setup process.
What should I do if I cannot find any wireless print servers during setup?
If no wireless print servers are found during setup, check if your network has an Access Point. If you are using an Ad-hoc network, or if the Access Point is encrypted, you may need to use Diagnostic mode instead. Refer to the Setup in Diagnostic Mode section for further instructions.
How do I configure the AXIS OfficeBasic USB Wireless G using the Set up Wizard?
Insert the AXIS OfficeBasic USB Wireless G CD into your CD drive and select the Set up Wizard to install the wireless print server and configure the connected printer. The wizard will automatically install necessary components and guide you through the setup process.
What are the default settings for the AXIS OfficeBasic USB Wireless G?
The default settings for the AXIS OfficeBasic USB Wireless G include Infrastructure mode, an SSID of <ANY>, automatic data transmission rate and mode, channel 6, open system authentication, no encryption, DHCP enabled, and a default IP address of 10.0.0.10.
How do I print a test page to verify the setup of the AXIS OfficeBasic USB Wireless G?
To print a test page, press the Reset button on the print server for 5 seconds. This will trigger the connected printer to print a test page displaying information such as the print server's IP address, firmware version, and other relevant details.
What should I do if the print server is not connecting to the network?
If the print server is not connecting to the network, ensure the Access Point is properly configured and visible. Check that the print server's DIP switch is set to NOR mode. If the Access Point is encrypted, use Diagnostic mode for setup. Verify the network settings and ensure the printer is properly connected via USB.