Tefcold BK (67 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to reverse the door direction?
To reverse the door direction, first remove the marked screws in fig. 1.2 and unlock the door hinge with the lock screw indicated in fig. 1.3. Remove the hinge and lift the door off. Place the door down, then swap the door spring and bottom curve as shown in fig. 1.4.
What are the safety instructions for installation?
Ensure the unit is placed in a dry and well-ventilated area. Avoid placing it near heat sources or direct sunlight. Keep away from explosive materials like gas, gasoline, or ether. Do not use asbestos or CFCs in construction.
How to connect electrical power?
The unit is designed for 220-240 V/50 Hz connection via a socket that should be easily accessible. For extra protection, follow the regulations on high-voltage safety. If using an older building constructed before April 1975, ensure there's an HFI circuit breaker installed.
How to start up the unit after delivery?
Before starting, clean the unit as described in maintenance instructions. Wait two hours if it was transported horizontally. Remove the compressor transport pin by taking off the entire rod as shown in fig. 1.8. Connect the power and turn on the control panel.
What does the thermostat display indicate?
The thermostat is located in the control panel, showing current temperature inside the unit. DP1 blinks when a parameter is changing; it stays lit if the compressor is active. DP2 indicates defrosting activation and DP3 shows evaporator fan operation.
How to adjust settings on the thermostat?
Press the key for 5 seconds to lock or unlock, which will show 'Pof' or 'Pon'. To view set temperature, press once. For evaporator temperature, hold the button. Adjust temperature by pressing up/down keys and save with a final press.
What are error codes for troubleshooting?
PF1 blinking indicates a faulty room sensor; PF2 blinking means a defective evaporator sensor. These do not affect operation but should be repaired promptly. The unit will attempt to maintain the set temperature until repair is done.
How does defrosting work?
Defrosting occurs automatically at programmed intervals. If frequent door openings or item changes cause excessive load, manual defrost may be needed by pressing for more than 3 seconds. Condensation water drains into a container in the compressor room.
What maintenance is required?
Clean both inside and outside with mild detergent and dry thoroughly. Use oil on external surfaces to maintain them. Clean condenser filters using vacuum cleaner or soft brush, avoiding chlorinated products that can damage stainless steel components.
How to dispose of the unit safely?
When disposing of an old refrigerator/freezer, ensure it is done in an environmentally responsible manner following local regulations. Be aware of specific requirements and conditions for proper disposal as mandated by authorities.
Related products from Tefcold
BK850
User manual 67 pages
RF1420
User manual 67 pages
RF710
User manual 67 pages
RK1420
User manual 67 pages
RK710G
User manual 67 pages
RK720
User manual 67 pages
RK1420G
User manual 67 pages
RK710
User manual 67 pages
BF850
User manual 67 pages
BK210
User manual 39 pages
CK7410G-I
User manual 39 pages
SK
User manual 39 pages
UC5210
User manual 39 pages
UC5410
User manual 39 pages
UC5360
User manual 39 pages
UC5240
User manual 39 pages
UC
User manual 39 pages
UC5310
User manual 39 pages
UC5480
User manual 39 pages
G-Line GF72-P
User manual 39 pages