Nice OXILR (132 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the OXILR radio receiver used for?
The OXILR radio receiver is designed for installation on a control unit to automate gates, garage doors, and road barriers. It supports long-range two-way radio communication and interfaces with transmitters using the LR two-way encoding system.
What are the key functions of the OXILR receiver?
The OXILR receiver can both receive and transmit information from and to the transmitter. It includes functions such as sending confirmation that a command was received and sending the status of the automation, such as whether a gate is open or closed.
How many memory locations does the control unit’s receiver have?
The control unit’s receiver has 1024 memory locations to store transmitters. Each location can store a single transmitter or a single key, depending on the memorization mode used.
How do I connect the OXILR receiver to the control unit?
Insert the receiver into the relevant slot on the control unit. Before inserting or removing it, disconnect the power supply to the control unit. Connect the antenna to terminal 1 of the receiver, or use an external antenna with a coaxial cable if needed.
How do I verify the encoding system of memorized transmitters?
Disconnect the power supply to the control unit, then restore it and count the number of flashes from LED B. One orange flash indicates LR technology, while five green flashes and one orange flash indicate no transmitter is memorized.
What are the steps for memorizing a transmitter in Mode 1?
Hold down key A on the receiver until LED B lights up green. Then, on the transmitter, press and release any command key within 10 seconds. LED B will flash green three times, confirming successful memorization.
How do I memorize a single key in Mode 2?
Press and release key A on the receiver the number of times corresponding to the command’s identification number. Then, on the transmitter, press and release the key within 10 seconds. LED B will flash green three times, confirming successful memorization.
How do I memorize the control unit Series/Address for the BusT4 network?
Disconnect the power supply, wait 5 seconds, then hold down key A and restore power. LED B will flash initially, then emit two short orange flashes. When a steady green light appears, release key A. If a red light appears, repeat the procedure.
What happens if the BusT4 network is used with multiple control units?
If multiple control units are connected via BusT4, the BusT4 network cable must be disconnected from the control unit where the Series/Address will be memorized before proceeding with the procedure.
Can a single key be associated with multiple outputs?
A single key can be associated with only one output, but the same output can be associated with multiple keys. This allows for flexible configuration of the control unit’s functions.