Nice Nemo WSCT (64 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I install the Nemo WSCT/SCT sensor?
To install the Nemo WSCT/SCT sensor, follow the step-by-step instructions in the Quick reference guide. Ensure the sensor is placed in an area with full sunlight exposure and proper ventilation for the wind sensor. Secure the device to a solid surface and adjust the sensor body as needed.
What is the maximum transmission range of the sensor?
The maximum transmission range of the Nemo WSCT/SCT sensor is approximately 100 meters in open field conditions. However, for optimal performance, it is recommended to install the sensor within 10-20 meters of the motor to ensure reliable signal transmission.
How do I calibrate the sun sensor?
To calibrate the sun sensor, set the trimmer to 'Test' and expose the sensor to bright sunlight. After 2 seconds, the motor should lower the awning, and the green LED should flash briefly. Then, cover the sensor and check that the LED alternates between red and green and the motor raises the awning.
How do I calibrate the wind sensor?
To calibrate the wind sensor, set the trimmer to 'Test' and rotate the wind sensor blades. The motor should raise the awning, and the LED should flash red briefly. Stop the blades and check that the LED alternates between red and green and the motor responds to commands.
What should I do if the motor does not respond to the sensor?
If the motor does not respond to the sensor, check that the sensor is properly powered and memorized in the motor's receiver. Ensure the sensor is installed in an area with unobstructed sunlight and ventilation. If the issue persists, run the diagnostics procedures to identify any malfunctions.
What is the operating temperature range of the sensor?
The Nemo WSCT/SCT sensor operates within a temperature range of -20°C to +55°C. This ensures reliable performance in a wide range of environmental conditions, from cold climates to hot weather.
How do I memorize the sensor in the motor receiver?
To memorize the sensor, hold down the 'P1' button for 10 seconds, then press the button of a previously memorized transmitter three times. Finally, press the 'P1' button again and check that the motor emits three signals, indicating successful memorization.
What are the technical specifications of the sensor?
The Nemo WSCT/SCT sensor is powered by a 64 mWp photovoltaic cell and operates at 433.92 MHz. It has an IP 44 protection rating and a working temperature range of -20°C to +55°C. The sun sensor measures light intensity from 3 to 80 klux, while the wind sensor (WSCT only) measures wind speed from 0 to 125 kph.
How do I check if the sensor is faulty?
To check if the sensor is faulty, run the calibration procedures outlined in the manual. If the sensor fails to respond correctly during calibration, it may be faulty. Additionally, use the diagnostics mode by pressing 'P1' briefly and observing the LED signals for any error codes.
What should I do if the LED is flashing red or green continuously?
If the LED is flashing red or green continuously, it indicates that the wind or sun setpoint has been exceeded. Check the sensor's position and ensure it is not obstructed. If the issue persists, run the diagnostics procedures to identify and resolve any malfunctions.