AgraTronix MT-PRO (140 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I preheat the tester?
Preheat the tester if the grain temperature is 20°F (11°C) more or less than the unit's temperature. Remove the cap, press ON-OFF to power on, fill the test cell, replace the cap loosely, wait 30 seconds, empty, refill, and tighten the cap until the pressure-indicator screw is flush. Press TEST to begin.
What should I do if the grain is too cold or hot?
If the grain temperature is outside the recommended range of 40°F (4°C) to 110°F (43°C), preheat the tester according to the instructions on page 05-3. Ensure the grain and tester are at about the same temperature to avoid condensation.
How do I take multiple readings for accuracy?
For accurate results, take three successive readings of the total sample and average the results. Empty and refill the tester with new grain from the sample between each test to ensure consistency and reliability.
What does the ERROR message mean?
The ERROR message indicates an electronic failure. If this message appears, contact the manufacturer for assistance. It may signal a malfunction that requires professional attention.
How do I calibrate the tester using the simple mode?
In Simple Calibration Mode, apply an offset to the displayed moisture regardless of the moisture content or range. This mode allows you to adjust the calibration offset at any time without needing to take a valid test. The offset will be applied to the entire moisture range of the grain.
How do I calibrate the tester using the advanced mode?
In Advanced Calibration Mode, you must first take a valid test before adjusting the offset for the tested grain. The adjustment will only apply to the moisture range of the grain just tested. This allows for different offsets to be applied to different moisture ranges of the same grain.
How do I clear the averaging data?
To clear the averaging data, press the AVG button to display the current average, then press the CLEAR button. The tester will display 0.0% (0), indicating that the averaging has been cleared and the data is no longer stored.
How do I select a different language?
To change the language, press the up or down arrow on the SELECT button until LANGUAGE is displayed. Press TEST to view the current language, then navigate through the language menu to select your preferred language from the list: ENGLISH, SPANISH, GERMAN, FRENCH, ITALIAN, SWEDISH, and PORTUGUESE.
What should I do if the test cell has condensation?
Condensation on the grain or test cell can lead to inaccurate readings. Ensure the grain and tester are at about the same temperature as the sample to avoid condensation. If condensation is present, allow the tester and grain to reach equilibrium before proceeding with the test.
How do I handle grain samples that are exposed to the environment?
Grain samples exposed to the open air can gain or lose moisture quickly. If a sample is to be held for even a short time before testing, place it in a tightly closed, air-tight container such as a re-closable bag or jar to prevent moisture changes.