Siemens BT 200 (90 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I charge the BT 200 battery?
To charge the battery, open the battery compartment and install the battery if necessary. Use the charging shell to charge the battery for approximately 4 hours. Note that the battery is delivered uncharged and the charging shell must be ordered separately.
What is the purpose of the BT 200?
The BT 200 is a diagnostic tool for PROFIBUS-DP systems, allowing users to perform tests without additional measuring equipment like a PC or oscilloscope. It includes features such as a log function, multilingual interface, and wiring tests.
How do I start a wiring test?
Press the TEST key to start the wiring test. The test can be performed with or without stations connected. After the test is completed successfully, one of two messages will appear on the display.
What should I do if there is a short circuit during the wiring test?
Locate and correct the short circuit. A common cause is incorrect application of shield braiding in the plug connectors. Ensure all connections are properly made and check the test plug connector is connected.
How do I switch to specialist mode?
To switch to specialist mode, press the ESC and OK keys simultaneously. This mode provides advanced functions such as station tests, branch tests, distance measurements, and a service menu.
What happens if there is a line or shield break?
A line or shield break can be caused by interruptions in multiple cores or the shield. Ensure the test plug connector is connected and the shield is not grounded. Check the plug connectors and connections first, then replace the line if necessary.
How do I handle error messages during a wiring test?
For error messages like 'wire mix-up', exchange the cores in the corresponding plug connector. For 'short circuit', locate and fix the issue. For 'line or shield break', check connections and ensure the shield is not grounded.
What is the energy saver mode on the BT 200?
If no keys are pressed for approximately 3 minutes and no measurements are being performed, the BT 200 automatically turns off to conserve power. This is known as the energy saver mode.
How do I navigate the menu in specialist mode?
Use the cursor keys to navigate the menu. The current cursor position is indicated by a flashing arrow, and the cursor changes to a modified arrow if the device is in log mode.
What should I do if there are none or more than two terminating resistors?
Place a terminating resistor at the beginning and end of the bus segment. If there are more than two, remove or deactivate all except the two at the ends. Use the '→' and '←' keys to navigate to the relevant page.