ELCA MAGO (100 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I activate the transmitter?
To activate the transmitter, press the START button (the green LED turns on), then the G button, and START again (the green LED flashes quickly). This sequence enables the transmitter; the user can modify it at any time. Note: If the receiver is not powered, the transmitter cannot be activated.
How do I start the system?
After activating the transmitter, press the START button (the green LED flashes slowly) to initiate the system operation.
How do I turn off the transmitter?
Press the Stop button. The transmitter enters a low-power state and can be stored for the next use.
What happens in case of a radio link failure?
If the receiver cannot interpret signals correctly due to interference or radio disturbances, it automatically stops, disables all outputs, and opens the Stop circuit. This action takes less than 500 milliseconds.
What is the emergency stop function?
When the Stop button is pressed, the system sends a Stop command, disables all outputs, and opens the Stop circuit. This action takes less than 100 milliseconds, ensuring immediate system shutdown.
What does the green LED indicate?
A green LED that flashes slowly (1 flash per second) indicates the system is functioning normally, the battery is charged, and transmission is correct. A green LED that flashes quickly indicates a disturbed transmission or a low battery.
What does the red LED indicate?
A red LED that flashes slowly (1 flash per second) indicates the system is functioning normally, but the battery is low (remaining autonomy is less than 1 hour). A red LED that flashes quickly indicates a disturbed transmission or a severely low battery.
What does the system do if the battery is completely discharged?
If the battery is completely discharged, the system will stop, and the red LED will flash quickly. The system may also shut down automatically if the battery is left discharged for an extended period.
How long does the system stay active after the last command?
The system remains active for up to 30 seconds after the last command. If no command is issued during this time, the system will automatically shut down. Activating any command resets the timer.
What should I do if the system is not responding?
If the system is not responding, check the battery status, ensure the receiver is powered, and verify that there are no obstructions between the transmitter and receiver. If the issue persists, consult the manual or contact ELCA for support.