SISTEMATICA TREND (100 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to pair a new receiver with the palmar?
To pair a new receiver, ensure the controller is powered on and wait a few seconds. Press START on the palmar to activate the controller. Press the desired button to assign the output, then press STOP to end the session. For newer devices, follow the automatic pairing procedure by pressing three buttons simultaneously within 5 seconds when the LED turns yellow.
What happens if the system is left unattended for too long?
If no action is taken for 2 minutes, the system will automatically go into standby mode and deactivate the emergency output (EO). This helps conserve power and ensures the system is ready for use when needed.
What does a red LED on the palmar indicate?
A red LED on the palmar indicates that the batteries are nearly depleted. The system's performance may be affected, and the batteries should be replaced as soon as possible. Any button pressed during this time will be interpreted as a STOP command for safety.
How to replace batteries in the STANDARD palmar?
To replace batteries, locate the battery compartment on the back of the palmar and remove the two screws. Take out the old batteries and insert new ones, ensuring correct polarity. Close the compartment and secure it with the screws. Always use alkaline batteries and avoid using rechargeable ones in STANDARD models.
What is the maximum range of the system?
The system has a maximum transmission range of 150 meters in an open field with no interference. This range may vary depending on environmental conditions and obstacles that may affect the radio signal.
What is the function of the MO (Master Output) button?
The MO (Master Output) button is an additional function that can be assigned to all output buttons. It allows simultaneous control of devices like a general solenoid valve or hydraulic pump, activating them in sync with the selected button's function.
What does the yellow LED on the palmar indicate?
A yellow LED on the palmar indicates an out-of-range condition in systems with SafetyPoint or Tilting Hand. It also flashes according to the selected page number during page changes and flashes three times to confirm successful pairing.
How long does it take to charge the EGO palmar?
The charging station takes 3 to 4 hours to fully charge the lithium batteries in the EGO palmar. Ensure the charging contacts are clean for a reliable connection. A red LED will flash during charging and turn green when fully charged.
What is the purpose of the photodiode sensor on the palmar?
The palmar includes a photodiode sensor (not an LED) that detects ambient light intensity. This sensor helps adjust the system's behavior based on lighting conditions, ensuring optimal performance in different environments.
What should I do if the palmar is not working properly?
If the palmar is malfunctioning, check the battery connections and ensure they are correctly polarized. If the issue persists, contact the authorized service center for assistance. Do not attempt to repair it yourself to avoid further damage or safety risks.