TECO 680 PLUS (320 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to safely transport the balancer?
Transport the balancer in its original packaging, keeping it in the position indicated. Avoid stacking more than two packages to prevent damage. Use a pallet with forklifts or a trolley for movement.
What are the storage conditions for the balancer?
Store the balancer in an environment with relative humidity between 20% and 95%, and a temperature range from -10°C to +60°C. Ensure the area is dry and free from moisture.
How to install the balancer?
Install the balancer in a secure, dry, and well-lit environment with at least 300 lux illumination. Ensure the floor can support the total weight of the machine and any additional loads. Follow all safety procedures and instructions provided in the manual.
How to mount the LCD monitor?
Attach the monitor support to the weight cover as shown, secure it with the four provided screws, and fix the monitor to the support using the four screws included. Connect the signal cable to the monitor and the power cable to the machine's rear panel.
How to mount the wheel protection?
Mount the wheel protector on the rotation shaft, aligning the keyway with the pin. Secure the metal tube with an M12 screw, insert it into the plastic protector's front holes, and attach it to the tube's rear end. Fasten the protector with the provided screw.
How to secure the machine to the floor?
Secure the machine to the floor by removing the triangular foot and using L-shaped brackets. Drill holes and insert Fischer M8 anchors, then attach the brackets to the anchors with screws and washers. Ensure the machine is positioned correctly and the surrounding space meets the minimum requirements.
How to install the ultrasonic sensor?
Insert the ultrasonic sensor cable into the metal tube's eyelets, secure the sensor support with M6 screws, and connect the cable to the connector on the machine's frame. Adjust the cable length near the connector to prevent connector deformation. Block the cable with the provided clip and ensure the calibration distance between the sensor and the reference mark is 270mm (±5mm).
What is the purpose of the ultrasonic sensor?
The ultrasonic sensor is used to automatically detect the wheel width. It helps in positioning the wheel correctly during balancing. Ensure the sensor is calibrated according to the instructions provided in the manual.
What safety precautions should be taken during installation?
Always disconnect the power cable before moving the machine. Avoid using the wheel mounting pin as a force point. Follow all safety warnings and instructions in the manual to prevent injury or damage to the equipment.
What should be done after completing the installation?
Place the machine in the chosen location, ensuring the surrounding space meets the minimum requirements. Verify that all components are securely fastened and that the machine is properly calibrated. Refer to the manual for any additional setup or calibration steps.