Hozelock 2212 (68 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How do I install the Sensor Controller?
To install the Sensor Controller, choose the correct tap adapter and attach it to the tap. Tighten firmly without using tools that could damage threads. Ensure the controller is positioned directly under an outdoor tap for optimal performance.
What type of batteries does the Sensor Controller use?
The Sensor Controller requires 2 x 1.5V AA (LR6) alkaline batteries. Rechargeable batteries should not be used as they may cause incorrect operation.
How do I set up automatic watering with the Sensor Controller?
To set up automatic watering, rotate the control dial to select Sunrise, Sunset, or both. Choose a watering duration from 2 to 60 minutes. The daylight sensor will adjust the schedule based on sunrise and sunset times.
How do I manually water using the Sensor Controller?
To manually water your garden, press the 'Water Now' button once to start irrigation. Press it again to stop at any time. Note that manual operation can only be done up to 3 times per minute to protect battery life.
What should I do if my Sensor Controller is not working?
If your controller isn't functioning, check the batteries and ensure they are alkaline. If the LED indicator flashes red, replace the batteries immediately. Also verify that the tap is open and there are no blockages in the hose.
How do I cancel an automatic watering operation?
To cancel an ongoing automatic watering cycle, press the 'Water Now' button again to override the schedule. The controller will then resume its programmed routine after this action.
What should I do if there is no water coming out of the valve?
If the valve opens but no water flows, check that the garden tap is fully open and ensure the hose pipe isn't twisted or blocked. If these are not issues, verify battery power as low batteries can prevent proper operation.
How do I test my Sensor Controller's battery level?
To check your controller’s battery status, press and hold the 'Water Now' button for a few seconds. A green light indicates good battery life, while red means the batteries are low and should be replaced soon.
What is failure prevention mode on my Sensor Controller?
Failure prevention mode activates when battery levels drop to a critical point that could cause system failure during operation. The LED indicator will flash red in this case, preventing automatic watering until new batteries are installed.
Can I use the Sensor Controller in cold weather?
The Sensor Controller is not designed for sub-zero temperatures (frost). During winter months, drain any remaining water from the system and bring it indoors to protect against freezing damage.