M7 QA-421 (66 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
What is the maximum air pressure allowed for the tool?
The maximum recommended air pressure during operation must not exceed 90 psi (6.3bar). Exceeding this pressure can lead to unsafe operating conditions for both the tool and the user.
How should the air supply be conditioned before use?
The compressed air should be cooled and have a water filter installed at the outlet end of the compressor. An air filter-lubricator device should also be installed between the tool and the compressor to prevent moisture and damage.
What safety precautions should be taken during operation?
Always wear hearing and eye protection, proper clothing, gloves, and breathing protection. Ensure the work area is clean, well-ventilated, and free from bystanders or hazards.
What is the correct way to replace the shank stone?
Use the supplied spanners to replace the shank stone. Turn counterclockwise to open and replace. Ensure the shank stone is correctly mounted and tightened before use.
How often should the tool be lubricated?
The tool should be lubricated regularly, every 3 to 4 hours of operation. Only use the recommended pneumatic oil to avoid damage and ensure proper performance.
What should be done before connecting the air hose?
Clean the hose with a blast of compressed air before connecting it to the air tool. This prevents moisture and dust from entering the tool and causing rust or malfunction.
What are the requirements for the air piping system?
The inlet pipe diameter should be as specified, the branch pipe should be twice as large, and the primary air supply pipe should be three times as large. The inlet pipe length should be less than 15 feet (4.5m).
What should be checked before using the shank stone?
Inspect the shank stone for cracks, chips, or defects before use. Ensure it is compatible with the tool and that its operating speed is higher than the tool's maximum speed.