Keysight U1252B (177 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to charge the battery of the multimeter?
To charge the battery, use the 24 V DC adaptor. Remove the test leads, connect the power cord to the DC adapter, and plug the Red (+)/Black (–) banana terminals to the V/Ω and COM terminals respectively. Ensure the polarity is correct and the mains supply voltage does not fluctuate by more than ±10%.
What safety certifications does the multimeter have?
The multimeter is safety-certified in compliance with EN/IEC 61010-1:2001, UL 61010-1 Second Edition, and CAN/CSA 22.2 61010-1 Second Edition. It provides CAT III 1000 V and CAT IV 600 V overvoltage protection with Pollution Degree II.
What is the purpose of the CAUTION notice?
A CAUTION notice indicates a hazard that could result in damage to the product or loss of important data if not properly followed. Do not proceed beyond a CAUTION notice until the indicated conditions are fully understood and met.
What is the function of the WARNING notice?
A WARNING notice denotes a hazard that could result in personal injury or death if not properly followed. Do not proceed beyond a WARNING notice until the indicated conditions are fully understood and met.
How to check the battery capacity?
Press and hold the button to check the battery capacity. The primary display will show 'bAt' and the 'SbY' will flash on the secondary display, indicating whether the battery needs charging.
How to start charging the battery?
Press the button to start charging the battery. If the battery capacity is over 90%, it is recommended not to charge it. The multimeter may indicate charging is complete after ten minutes, which is normal for rechargeable batteries.
What are the input terminals and overload protection specifications?
The input terminals include COM for voltage, resistance, capacitance, temperature, and current. Overload protection includes 1000 V R.M.S for voltage, <0.3 A short circuit current for resistance, and 30 kA/fast-acting fuse for current measurements.
How to measure AC voltage?
Set the rotary switch to AC voltage mode. Connect the red and black test leads to the V. mV (red) and COM (black) terminals. Probe the test points and read the display. Press to display dual measurements.
How to measure DC voltage?
Set the rotary switch to DC voltage mode. Connect the red and black test leads to the V. mV (red) and COM (black) terminals. Probe the test points and read the display. Press to display dual measurements.
How to enable the Filter for DC measurements?
To enable the Filter, switch off the meter, turn the rotary knob to a non-OFF position while holding the button until you hear a beep. Scroll through the menu items until 'FiLtE' is shown, then press to enable the Filter and save your changes. This helps filter out high frequency AC components for accurate DC voltage readings.
Related products from Keysight
U1242B
User manual 91 pages
U1241B
User manual 91 pages
U1232A
User manual 161 pages
U1231A
User manual 161 pages
U1233A
User manual 161 pages
U1272A
User manual 165 pages
U1272A
User manual 193 pages
U1271A
User manual 165 pages
U1271A
User manual 193 pages
U1251B
User manual 177 pages
U1251B
User manual 177 pages
U1253B
User manual 193 pages
U1273AX
User manual 219 pages
U1273A
User manual 219 pages
U1282A
User manual 309 pages
U1281A
User manual 309 pages