TP-Link TL-EAP115-WALL (76 pages)
Tags
Languages available:
No exact matches found. Please change your query
Need help?
Do you have a question about the product that is not answered in the manual?
- Receive updates on solutions
- Get answers to your question
Product description:
Frequently Asked Questions
How to power the EAP?
The EAP must be powered through a PoE switch or similar PSE device. A DHCP server, typically a router, is required to assign IP addresses to the EAP and connected clients.
What is needed for installation?
Ensure you have a pre-installed wall junction box, an RJ45 plug, a triangular screwdriver (for EAP115-Wall), a Phillips screwdriver, and a PoE switch before starting the installation.
Can EAP be installed in different boxes?
The EAP can be installed in an 86mm wall junction box, a standard EU wall junction box, or a standard US wall junction box (only for EAP225-Wall). Ensure the junction box has a PoE switch connected.
How to connect the Ethernet cable?
Connect the Ethernet cable inside the junction box to the UPLINK+PoE port of the EAP. Ensure the cable is not under tension to avoid damage.
What tools are required for installation?
You will need a Phillips screwdriver, a triangular screwdriver (for EAP115-Wall), and a screwdriver to remove the faceplate of the EAP and junction box.
How to secure the EAP in the box?
Use the provided screws and a triangular screwdriver to secure the EAP in the junction box. Ensure the screws are tightened but not over-tightened to avoid damaging the device.
What is the network topology for EAP?
The typical network topology includes a router, a PoE switch, an Omada controller, a management host, and multiple EAPs. Clients connect to the EAPs to access the network.
How to configure the EAP software?
Install the Omada Controller software on the management host, then use the Adopt function to onboard the EAPs and change their status from Pending to Connected.
Can the management host be in a different network?
Yes, the management host can be in the same network segment as the EAPs or in a different network segment, as long as the network configuration allows communication between the devices.
What if the junction box is too small?
If the junction box does not provide enough space for the EAP and Ethernet connection, use an open or deeper junction box to accommodate the device and cable without strain.
Related products from TP-Link
Pharos CPE210
User manual 60 pages
EAP115 V4
User manual 60 pages
EAP245 V4
User manual 60 pages
EAP115
User manual 60 pages
EAP265
User manual 60 pages
EAP265 HD V1
User manual 60 pages
EAP225 V5
User manual 60 pages
EAP650-Outdoor V1
User manual 60 pages
EAP660 HD V2
User manual 60 pages
EAP653
User manual 60 pages
EAP690E
User manual 60 pages
EAP690E
User manual 60 pages
EAP115 V2
User manual 60 pages
EAP670
User manual 60 pages
EAP620
User manual 60 pages
EAP650 V2
User manual 60 pages
EAP610
User manual 60 pages
Wall-Plate Access Point
User manual 72 pages
EAP230-Wall V1
User manual 76 pages
EAP235-Wall V1
User manual 76 pages